Does this mean I should buy another Arduino? I used the cheaper Arduino and it also had the same effect. Also, the sticky double sided tape on my breadboard came off so I used my tape to re seal the metal portions but if I was to insert a wire, it doesn't feel securely placed, it feels really loose for some reason. Should I buy another breadboard and jumper wires also?
- Viewing Profile: Posts: kushshah0423
Community Stats
- Group Members
- Active Posts 15
- Profile Views 8,209
- Member Title Member
- Age Age Unknown
- Birthday Birthday Unknown
-
Gender
Not Telling
User Tools
Friends
kushshah0423 hasn't added any friends yet.
Latest Visitors
Posts I've Made
In Topic: Arduino uploaded code not working
18 March 2015 - 05:12 AM
In Topic: Arduino uploaded code not working
21 February 2015 - 04:34 AM
I will buy the multimeter tomorrow and check, but for now I've encountered another problem. As if it couldn't get any worse
. When I connected the batteries with the wire this evening, the arduino would not work. No lights or anything. I was really worried that I might have just fried it. Fortunately I had a fake (non-official) board from Amazon to test that with. The fake one did not work either. I plugged the robot in with the computer and nothing happened. I touched the capacitors and they were warm so I took the arduino out of everything. As I was doing this. I removed the 5v pin from the board and everything started up like any usual board. I was surprised so I put the 5v back in for curiosity. The board stopped working. I connected only the original board to the computer and it worked fine. So I think there is a problem with something involving the breadboard or wiring.
In Topic: Arduino uploaded code not working
08 February 2015 - 12:11 AM
The male headers are secure. Whenever I connect the 2 wires to the battery, the right motor starts spinning slowly. Then, whenever I move the headers a little like a tilt or anything, the following outcomes happen:
Both motors stop
Right motor stops moving and left starts
Right motor moves opposite direction while left moves backwards slowly
In Topic: Arduino uploaded code not working
07 February 2015 - 03:09 AM
In Topic: Arduino uploaded code not working
01 February 2015 - 07:37 AM
Sorry for the late reply, I've been busy the last couple of weeks to be able to work on the robot. I tried powering the servos from the 5v and GND pins like you said, but when I uploaded the code, nothing happened. I do not have a multimeter unfortunately, but, just to check if the jumper wires were at fault, I used different ones and no difference detected. However, I think I may have detected the issue. When I checked every wire to see if it was correct and firmly in place, I noticed the servo cables. The 2 cables are on the breadboard but when I moved the servo cables(not the pin but the wire itself), the servos changed direction and one of them stopped working at times whenever I move the cable in one direction. I'm not sure if this is the root of the problem, but that's as far as I got.
- Viewing Profile: Posts: kushshah0423




Find content
