Jump to content


RichC

Member Since 06 Jun 2014
Offline Last Active Jun 12 2014 01:22 AM
-----

Topics I've Started

Bluetooth HC-05 - drop incoming TX voltage level?

06 June 2014 - 12:00 PM

Hi Guys,

Nathan, thanks for sending my 2 bluetooth HC-05 units so quickly!

 

Question:

I've seen posts where it is recommended to drop the incoming +5 VDC signal level to about +3.3 VDC to the HC-05's RX pin.

Then again, I've seen posts that say it's already taken care of on the breakout board between the pin and the BT unit with SMD resistors etc.

So, do we need to drop the voltage on the HC-05 modules that Foxytronics ship? - If so,  would probably use a voltage divider setup like below:

 

Thanks for your help.

 

Rich.

 

0J1423.600.png?ba900a2037e04a07928013504