Jump to content


Nathan's Blog



Balancing Robot #2 - Update 2

Posted by Nathan House, in Balancing Robot #2 20 July 2011 · 2,699 views
Build Log
I had to stop working on this project towards the end of the last school semester, but have since resumed work. The robot now has a frame, made out of a thin piece of acrylic from Lowes. The acrylic is perfect as a frame because it's lightweight and strong. The electronics and batteries will go inside the frame. Here's a picture:
...


Balancing Robot #2 - Update 1

Posted by Nathan House, in Balancing Robot #2 14 July 2011 · 2,621 views
Build Log
My last attempt at building a balancing robot didn’t turn out so well. It looked cool, but did not balance – at all. I blame some of this on the Vex parts I was using, but just as much of the problem was caused by my inadequate control software.

This time, I’m using a Dual Motor GearBox from SparkFun, a SN754410 dual H-bridge IC to drive the two...


MPLAB X IDE – First look

Posted by Nathan House, 14 July 2011 · 9,021 views

I recently found out about the new IDE Microchip has been working on, called MPLAB X. The new development environment for PIC microcontrollers has a plethora of new features and offers a much nicer user interface than its predecessor, MPLAB v.8. Rather than using a proprietary development environment, like the previous versions of MPLAB, Microchip opted to...


Cheap linear rails idea for CNC machines

Posted by Nathan House, in CNC 14 July 2011 · 6,324 views
CNC
I’ve been trying to come up with a better method then skate bearings, which my current CNC machine uses, and I think I might be on to something..

One problem with my first CNC machine is that accuracy isn’t that great, which is caused, in part at least, by the way the axis slide back and forth. Another issue is the z-axis not being supported well enough,...


PIC18F4550 SMT Board Finished!

Posted by Nathan House, in Electronics, Completed Projects 14 July 2011 · 7,308 views
Electronics, Completed Project
I finally finished my first SMT PCB, which I’ve been working on for a while. It was designed to be a general purpose board for a PIC18f4550 microcontroller. It has mostly 0805 parts on it, with the microcontroller being a TQFP package.

Schematic:

http://www.foxytroni...ery_1_3_620.png


PCB:

http://www.foxytronics.com/u...


Starting out with SMDs

Posted by Nathan House, 14 July 2011 · 2,795 views
Electronics, SMD
Posted Image

I’ve always been a little intimidated by SMDs. I mean, they are really, really, small, and I was under the impression you had to have a hot air rework station to use them. Recently, however, I came across a great article on SparkFun showing how to use a skillet to reflow...


CNC design finalized

Posted by Nathan House, in CNC 14 July 2011 · 2,994 views
Build Log
Over the summer I designed a small CNC machine for dilling PCBs. The design has been finalized and I have begun building it.  

Posted Image


dsPIC square bot completed!

Posted by Nathan House, in Completed Projects 14 July 2011 · 2,976 views
Completed Project
Posted Image

My latest project has been integrating my newly created electronics board with the frame I built using parts from a Vex Robotics kit. I’ve also finished writing both the software on the PIC microcontroller, and the PC program that I wrote for debugging. To make things a little...